The Comprehensive Guide to Positioning a Jack on a Harley Tri Glide

Introduction

Whether you're a seasoned rider or a curious novice, understanding the proper placement of a jack on a Harley Tri Glide is crucial for safe and effective lifting. This comprehensive guide will provide you with all the necessary knowledge, step-by-step instructions, and troubleshooting tips to ensure a seamless experience.

Understanding Your Tri Glide's Frame

The Harley Tri Glide's frame is composed of a robust steel structure that provides stability and support. To safely elevate the bike, it's essential to choose the correct lifting points that can withstand the weight distribution without causing damage.

Identifying Suitable Jacking Points

Front of Vehicle:

• Frame Tubes: Locate the two parallel steel tubes that run along the front of the frame, just below the handlebars. These tubes provide a secure point for jacking up the front wheel.

Rear of Vehicle:

• Rear Axle: Position the jack beneath the center of the rear axle housing, ensuring the saddlebags are removed for clearance.
• Swingarm: Alternatively, for lifting the entire rear end of the bike, place the jack directly under the swingarm, between the rear wheel and the transmission housing.

Additional Safety Considerations

• Use a Suitable Jack: Choose a jack with sufficient capacity to lift the weight of your Tri Glide, typically around 1,500 to 2,000 pounds.
• Stable Ground: Ensure the jack is placed on a firm and level surface to prevent any movement or tipping.
• Engage Parking Brake: Apply the parking brake before lifting to secure the bike in place.

Step-by-Step Guide to Jacking a Tri Glide

Materials Required:

• Hydraulic floor jack or motorcycle jack
• Jack stands (optional)

Instructions:

1. Park and Secure: Park the Tri Glide on a flat and stable surface. Engage the parking brake to secure the bike.
2. Remove Saddlebags (Rear Lifting Only): If lifting the rear end, remove the saddlebags to provide access to the rear axle or swingarm.
3. Position the Jack: Place the jack beneath the designated lifting point on the front or rear of the vehicle.
4. Lift Gradually: Slowly pump the jack to lift the bike until the desired height is reached.
5. Secure with Jack Stands (Optional): If desired, insert jack stands under the bike for additional stability.
6. Lower the Bike: Once work is completed, gradually lower the jack to bring the bike back to the ground.

Tips and Tricks

• Use a cushioning material, such as a rubber pad, between the jack and the frame to prevent damage.
• Lubricate the jack points periodically to ensure smooth operation.
• Never lift the bike by the fenders or any plastic components, as they may crack under pressure.

Common Mistakes to Avoid

• Overloading the Jack: Do not exceed the capacity of the jack, as this can lead to instability or damage.
• Lifting from the Wrong Points: Jacking from inappropriate locations can cause structural damage or bend the frame.
• Ignoring Safety Precautions: Always ensure a secure and stable setup before lifting to prevent accidents.

Reference Tables

Table 1: Recommended Jack Capacities for Tri Glides

Table 2: Lifting Points by Model

Table 3: Estimated Lift Times

Conclusion

掌握在 Harley Tri Glide 上放置千斤顶的位置对于安全可靠地抬升您的摩托车至关重要。遵循本指南中概述的步骤、注意事项和提示，您可以自信地执行这项任务，为您的维护和维修活动做好准备。记住优先考虑安全，选择适当的千斤顶，并在进行任何提升操作之前建立稳定的环境。